Resetting The Motor Stops On A Sunsetter Awning

A jog is a short back and forth movement of the motor.

Resetting the motor stops on a sunsetter awning.

Press the neutral stop button on the remote. The motor could be overheating. Plug the awning back in if necessary and try using the awning again. A for 5 seconds until the motor jogs then release.

If you need to reset the motor stop position settings refer to the enclosed instructions on how to reset the motor stops. Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. Unplug or stop using the awning and wait a few minutes. Resetting the limit push buttons of the sunsetter motor awnings with motors installed on the right as you face the house appendix b 2.

When the motor stops press and holdthe programming button on the back of the remote transmitter see fig. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. Limit how often you open and close the awning as overuse on a hot day could cause the motor to cut out. From a stepladder locate the limit push buttons on the motor.

Motor to lose stop position settings which will require resetting the motor stop positions. A very specific problem but maybe i m not the only one. These push buttons will be on top of. Remove four 4 2 phillips screws.

Plug the power cord back into the outlet.